Tomos forum

Hi everyone!

First, I'm from Slovenia so sory for bad English

I was looking on the internet and saw Tomos moped with different seats so I decided to make one like that for myself.
I frame and front "shock absorbers", all modifications are made by me.







Then I ordered DMP 45mm kit for Puch and made Homoet P6 exhaust.






Front disc brakes


Homemade clip-on rudder



Almost finished





First run:
http://www.youtube.com/watch?v=pZNjnLsaEWA


Please comment

looks nice...only needs some paint?

But I have a problem: when I open full gas this happens http://www.youtube.com/watch?v=iuhTdXqd11k
I use 17.5 YSN carb with 85 main nozzle (on the tape is 90). Now with 85 and without air filter it goes better, air needle
is almost fully unscrewed.


Before today I had connected RED and GREEN connection. Today I connected tube only on RED connection and sealed the tube on other side. GREEN connection is free open.


Any ideas how to repair this?
I would be very thankful

looks nice...only needs some paint?

Jup, I decided to make it drivable, when I'll see everything is OK, im going to paint it

Nice
Puch cilinders are very fast on a tomos

tastes differs, I find this nothing, but that brake in front looks good,

Today I took sprinter to pieces and started to grind it...

Your front wheel is the wrong way around.

i think that it have been done on purpose to assemble the brake claw at the good side of the foreleg?

i think that it have been done on purpose to assemble the brake claw at the good side of the foreleg?

jep, wheel is turned because of dics braking

Then nevermind I said a thing.

little update
now im busy with back of the frame (seat)

finished


in progress

oehh very nice

today I was grinding the seat and correct faults, holes...

and I get this: http://www.tomoshop.nl/catalog/topracin ... p-805.html







what do you think about that head (squish), is OK or to wide squish bend

http://i537.photobucket.com/albums/ff33 ... C00983.jpg

squish clearence (from piston to head): 0.85mm
squish bend: 10mm
bore: 45mm

volume is about 65.5-6ccm, compression is strong

some more pics, now i need to use more genteel sand paper

Starting to look better and better.

update
wheels are finished, except i need to buy new bearings





hope u like it

Yes,i like it, it looks very nice,

Nice its gonna be a pretty fast an good looking tomos

Looks very very good, seriously.